	MICROLUX Technology Pte Ltd

TORQUE & ANGLE SERIES

In the industrial tightening you may need different control strategies and solutions.
The most common cases are: torque control with angle monitoring and angle control with torque monitoring.
Kolver T & A control units can manage all such strategies.
The Torque/Angle Control
The main parameters to be controlled are the tightening torque applied to the screw and the rotation angle of the screw, with priority to the torque value. If the torque and angle values found by the system are within the programmed settings, the motor stops automatically and the indication of OK cycle (green led turned on) is given, otherwise an error (red led) is generated.
The Angle Control
The main parameter to be controlled is the rotation angle of the screw. The motor stops automatically when the pre-set angle value has been reached and an indication of OK cycle (green led turned on) is given.
Main features:
• 8 different programs for custom joints with description
• Selection of factory pre set joints (hard to soft)
• User friendly menu
• Nm and lbf.in unit
• Password protection

The T & A system always consists of 3 units: T&A screwdriver + T&A control unit + T&A box (code 020025).
T&A screwdriver: any PLUTO screwdriver (PLUTO../TA).
T&A control unit: any control unit of EDU1AE series (EDU1AE../TA).

47, Jalan Pemimpin, #04-04, Sin Cheong Building, Singapore 577200.

Tel : +(65)-68936970 Fax:+(65)-68936971 Email : sales@microlux.com.sg